Axle Pusher (26 MM/30 MM) – Anodized

Description

Axle Pusher (26 mm/30 mm) – Anodized

26mm – Orange

30mm – Orange

MADE IN THE USA

26 mm size fits the FRONT axle of the Super Enduro and all KTM full size dirt bikes since 2004.

This little addition to your tool kit can save you time and expensive damage to your front axle.

Don’t grab a hammer and punch to drive your axle out! – You can damage the threads and mar the surface.

Remove your front axle bolt.
Thread this axle pusher into your FRONT axle and use the 10mm socket and t-handle to tap the axle out with no damage and no frustration!
This stay in the axle so it’s not lost and always handy.

In your stock KTM LC8 tool kit you should have a 10mm socket, the same one used to loosen the fork leg end clamping the axle.  Use this to thread it into the axle.  Thread it in until is fully seats at the bottom of the threads.

Push or tap on the end of your “T” handle with your hand, small rock, NO hammer should be required.

This will save the axle threads from any damage caused by a punch.

When you reinstall the axle, add some grease or a small amount of engine oil off your dipstick if on the trail.

Available in Orange Anodized.

CJD-AP-26 Orange 26mm

CJD-AP-30 Orange 30mm